Manufacturing Processes

University of the South Pacific

Course Description

  • Course Name

    Manufacturing Processes

  • Host University

    University of the South Pacific

  • Location

    Suva, Fiji

  • Area of Study

    Mechanical Engineering

  • Language Level

    Taught In English

  • Prerequisites

    MA112 and MM212 or En106

  • Course Level Recommendations

    Upper

    ISA offers course level recommendations in an effort to facilitate the determination of course levels by credential evaluators.We advice each institution to have their own credentials evaluator make the final decision regrading course levels.

    Hours & Credits

  • Credits

    3 - 4
  • Recommended U.S. Semester Credits
    3 - 4
  • Recommended U.S. Quarter Units
    4 - 6
  • Overview

    This course is designed to develop an understanding of various manufacturing processes. Since the economies of most countries in the south pacific region are driven by manufacturing industries, it is important that mechanical and manufacturing students are well versed with manufacturing processes. It builds the foundation for advanced courses in mechanical engineering such as manufacturing systems and engineering project.
    Topics
    1. Casting: casting principles, sand casting, shell mould casting, permanent mold and die casting, precision casting, centrifugal casting and vacuum molding.
    2. Mechanical Working: cold and hot forging, open and closed die forging, soil forging, radial forging, rolling, direct and indirect impact extrusion, wire drawing and tube drawing.
    3. Sheet metal working: shearing, punching, blanking, roll forming, bending, stretch forming, deep drawing, spinning, powder metallurgy and applications of powder metallurgy.
    4. Metal finishing: hot dripping, electro plating, electroless plating, metal oxide coating, anodizing and enamel coating.
    5. Selection of manufacturing processes: the factors that influence the choice, the type of material, size and shape of the component, functional requirements, tolerance and surface finish, quantity and rate of production and production of scrap.
    6. Thermoplastic and Thermoset processes: injection molding, extrusion, blow molding, compression molding, transfer molding and foam molding.
    7. Composite processes: hand lamination, spray lamination, matched die molding, resin injection, tape laying, filament winding and pultrusion.
    8. Engineering dimensional metrology: measuring devices, measurement principles, linear and angular measurement, errors in measurement, surface finish and texture, standards and accuracy.
    9. Introduction to advanced manufacturing processes: Overview of sintering, abrasive water jet machining, electrochemical machining and ultra sonic machining.

Course Disclaimer

Courses and course hours of instruction are subject to change.

Eligibility for courses may be subject to a placement exam and/or pre-requisites.

Some courses may require additional fees.

Credits earned vary according to the policies of the students' home institutions. According to ISA policy and possible visa requirements, students must maintain full-time enrollment status, as determined by their home institutions, for the duration of the program.

Please reference fall and spring course lists as not all courses are taught during both semesters.

Availability of courses is based on enrollment numbers. All students should seek pre-approval for alternate courses in the event of last minute class cancellations

Please note that some courses with locals have recommended prerequisite courses. It is the student's responsibility to consult any recommended prerequisites prior to enrolling in their course.